![]() If the bootloader for your board should not be available you can simply dump it into a binary file also using the J-Link Commander and the command savebin.įor more information see our J-Link user manual. If you want to revert the Arduino board to its original state you need to flash the Arduino bootloader of the corresponding board you are using.įor this the now established connection between your J-Link and the board can be used.Īs a tool we recommend using J-Link Commander where you can use commands loadfile/loadbin to flash the bootloader file. Note: Using this example project will erase the Arduino bootloader and allow bare-metal debugging of the target device. It is a simple Hello World sample and can be downloaded here: The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Arduino Nano 33 BLE board. You can set Ozone to attach to the target device via Debug->Start Debug Session->Attach to Running Program.īare-metal Debugging Example project for SEGGER Embedded Studio We recommend using Ozone, the J-Link debugger as it offers the best debug experience with SEGGER debug probes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |